News

Cooling tower noise problems are common in the market, and its noise pollution has a wide range and strong penetration, affecting residences 50 meters away. Therefore, when noise pollution occurs, the impact is significant, and many owners who install cooling towers are looking for solutions. Guangdong Teling Air Conditioning is committed to noise pollution control, and cooling tower noise problems are also noise pollution problems that enterprises often overcome. There are many cooling tower noise reduction cases every year. Let's take a look at common noise reduction measures for cooling towers.

Guangdong custom-made cooling tower manufacturers tell you how to arrange the cooling tower for better efficiency.

Cooling Tower Overflow Status and Solutions Multiple counterflow cooling towers are selected for automatic control operation. Electric valves are used at the inlet of the cooling towers, but not at the outlet. Under low load conditions, during the operation of a single cooling tower, due to the smaller amount of water in the operating tower, the water level in the cooling tower sump increases, which can lead to cooling tower overflow. In another scenario, the cooling tower may overflow. When multiple cooling towers of different sizes are connected together, the water levels in the towers are different, the sump is low, and the tower must overflow.

Cooling tower water discharge is achieved through the cooling pump and gate valve. The water pan below the cooling tower has a wastewater outlet for water discharge. The following maintenance procedures for the cooling tower are described below. 1. First, depending on the equipment provided by your cooling tower, stop the equipment, then stop the cooling tower pump and cooling fan. Turn off the main power and hang a sign (e.g., "Work in progress, do not turn off"). 2. Check the cooling tower to confirm that it is in the shutdown state. Proceed only after confirming successful shutdown. 3. The cooling tower outlet is generally located below the inlet, at a lower position. Otherwise, there will be a rubber plug at the bottom of the water tower. Locate it and you're good to go. Based on these three points, we can understand how to safely drain the cooling tower water, thus avoiding many unnecessary problems. We hope the above points will be helpful.