What are the roles of cooling tower components in cooling tower renovation?

The heat exchange capacity of a cooling tower is mainly determined by the air-water ratio. Traditional technologies are not very efficient and the effect is not obvious. If the cooling tower is retrofitted with Mali Liangji cooling tower accessories, the shaft power of the water turbine can be the same as the motor power.

What are the key roles of Mali Liangji cooling tower accessories in cooling tower retrofitting?

1、 Cooling tower packing retrofit Packing is the core component of the cooling tower. Due to long-term contact with water, plus corrosive chemicals added to the water during water treatment, and exposure to sun and rain, the packing, which is made of plastic sheets, ages and becomes brittle after five or six years of use, requiring retrofitting.

2、 Cooling tower power system retrofit ;The power system includes motors, fans, and reducers. It is the heart of Mali Liangji cooling tower accessories. Because the power components are built inside the tower and are subject to the long-term effects of humid hot gases, these power components, made of cast iron and aluminum alloy, either burn out motors or cause serious wear and tear on reducer bearings or serious oxidation and breakage of fans, making them key targets for retrofitting.

3、 Cooling tower base Because it is a water carrier, it holds acidic and alkaline water for many years. In addition, the water treatment personnel step on it monthly inside the tower, causing serious cracking of the base over time. Therefore, resin patching and thickening of the base is also part of the retrofitting.

4、 Another meaning of Mali Liangji cooling tower accessory retrofit is to dismantle the old tower and install a new one. The service life of a cooling tower is 12-15 years. After reaching the service life, the tower frame, including the power system and heat dissipation packing, will be aged to varying degrees. When a large number of repairs and patching occur, it means that the life of the tower has come to an end. The old tower needs to be dismantled and a new tower installed; this includes the re-fabrication of the steel structure foundation, the replacement of pipelines, and the replacement of lines to achieve the required refrigeration capacity of the chiller.